Since the popularity of LCD TV and smart TV, people have already cast off the clumsy old analog digital TV. The size of the TV has also changed from the original big head to a thin cuboid. In the past, no matter where the TV was placed, there must be a TV cabinet or a table to place it. But now it is no longer necessary, because the LCD TV and smart TV are light enough to be picked up by one hand and light enough to be hung on the wall. Now I want to tell you how to install the TV wall mount.
1. Before installing the TV mount, carefully check the bearing capacity of the wall. The interior walls of the compartments in many rooms are all hollow, and the wall mounted TV can not be installed at all, so the TV can only be placed on the cabinet. According to the TV installation service standard: the load-bearing capacity of the installation wall should be no less than 4 times of the actual load-bearing capacity of the TV. After installation, the TV should not be tilted by 10 degrees.
2. The installation environment is also very important. First of all, we can check the humidity in the room. No matter what brand of TV is, it can not be in a humid environment for a long time. Since many TVs do not have waterproof protection, the circuit board inside the heat dissipation grid will directly contact with the outside air. If the TV is installed too close to the humidity, the machine will be damaged. In addition to the air humidity, the installation position of the TV mount should also be considered. Generally speaking, the distance to watch TV should be at least 3-5 times of the diagonal distance of the display screen.
3. It is very important to buy the TV mount. If it is not installed properly, it may fall off the rear wall, and the consequences are very serious. When selecting the TV mount, you should choose the appropriate wall hanging bracket, and its strength and endurance should be guaranteed.
4. The TV mount needs to be classified according to the type of wall, and different wall surfaces need different installation methods. If the ordinary brick wall needs to be installed with a TV mount, it only needs to drill holes on the wall with an impact drill, then insert plastic expansion pipes, and finally fix the TV mount with screws to hang the TV.
5. If it is a board wall, it is necessary to select the positioning of the TV mount first. First, a small hole shall be made at the fixed position with a art knife, and then a 2cm thick long wooden batten shall be placed on the TV rotating mount, so that the self tapping screw can pass through the gypsum board and enter the wooden batten during self tapping, so as to increase the stress area.
